Guys can u fix sensor issue plssssssssssssss
In 1.3 I want to slide down to turn on wifi but sometimes when I try slide down watch doesn’t understand this is reallly annoying.
Plus step count shows with minus sign
Actually did but for safety did 2nd time.Currently I have issue with notifications.When notifications comes out I try slide it to see but shows 0 notification s
hello, i went to 1.3b3. didn’t like it. not a daily driver. so i went down to faw 1.4 , worked good then went to version faw 1.0 installed fine, tried locale update to go to faw 1.2, no go. got the dying android robot. tried to download the legacy 1.0 but says it’s not there. what do i do
Flash stock and then update to 1.0
The FAW version is designed to not allow downgrade apart from flashing back to stock.
1 Like
Where can I find the stock rom? And is the version 1 the legacy rom, if so the links do not work.
the stock rom is 1.4 and you’ll find the newest version of 1.0 in the top post of the following thread: International Firmware Beta [V1.3] (Optimus2, Prime2, LEM12Pro, LEM14, LEM15)
2 Likes
thanks, BUT version 1 that you referred to is a zip file and version 1.4 does not have local update
That’s correct.
Stock firmware requires flash tools and the international firmware is for updating from the watch storage using the built in OTA software.
okay, when i put the version faw 1 in watch storage the file is a zip and there are question marks on all the other files in the zip, then it says file is unknown format
I hope you read up on how to use the update zip? This is for the S10 LEM 14 but it is the same as all the other watches.
Make sure you only download the FAW firmware from this post. V1.0 is attached to it
When I ordered my watch version was 1.5
Does not matter.
If you flash 1.4 you can take the OTA if it is available.
Or just update to International v1.0.
Either way, flashing v1.4 stock is fine
Just remember that you need flash tools to install stock firmware.
1 Like
After flash just tried OTA update no update available.
But in the end end up with FAW 1.0 cause tap to wake function is really nice I am trying to avoid buttons use to make their life longer 
Yep, fair enough 
Thank you, I’m now at version 1.0 now can I go to 1.2 or do I need to go to 1.1 then 1.2. I’ve tried 1.2 but got the dead robot.
what option i have to choose for downgrading from the drop down of SP Tool
There are three option here
Can i directly flash 1.4 from 1.3 B3
or
i have to flash 1.0 first than flash 1.4
what option do i have to choose from the drop down for downgrading the FAW
Just flash it using firmware upgrade mode.
If you have read up on the process you will find out.
Anyway, if you use download only you should factory reset.
Use firmware upgrade option means that you don’t need to factory reset.
Just NEVER use format all + download or you will lose imei and Mac addresses etc…
2 Likes
What would cause version 1.1 or 1.2 not to install?