I hope someone can help me. I used my watch this morning for a run, its a Domino DM368. After the run I put the watch on charge. Came back after a couple hours to find the watch rebooting. I could not switch the watch off, so I waited until the battery went flat. I thought I could just reflash the firmware to fix the reboot fault, but SP Tools will not detect the watch so I can not do the firmware. I have uninstalled and reinstall the drivers, but still no luck, any suggestions? The battery at the moment is dead, do I need to have some charge in it for SP Tools to detect the watch? If I try to start it up it starts to boot loop again.