For example browser can do this, simply pretty much anything that writes to disk while screen is open , a long list.
What I left under that video was that:
Thor 6 survived because needs to encode video in a lower resolution than LEM 12 Pro I guess. LEM 12 was alive because Android 10 is fresh yet. Kospet was dead because of both. The thermal engineering point is valid for everything but does not help that too much. Plus, this review should also mention CPU temperature.
they are aware of the situation and if any solution is found we will make sure you know about it.
Deal. This was the goal @pablo11. Thank you for all your effort.
A better solution might be AccuBattery which shows the discharge in mA:
This is significantly better for comparison as the percent per hour consumption is just mostly based on the battery capacity:
For example the standby usage of the hardware is around ~10mAh, that would roughly translate to 400 hours standby on a 4000mAh battery and 90hours for a 900mAh battery.
This is around 0.25% per hour for the 4000mAh battery and around 1.10% for the 900mAh battery, but it sounds a lot worse for the smaller battery even if the total consumption is identical.
I wouldn’t interpret to much into this results, the thermal shutdown is working as intended.
They could simply add some underclocking/undervolting to reduce the thermal discharge to not even noticeable and without sacrificing performance.
It is even possible to increase the performance due to lifted thermal constraints as shown here.
Yes I agree with R_Sauvalle - please don’t eliminate video recording as it is one of the main reasons I bought this watch. I do not expect to do recordings of more than a minute or so and thus I don’t believe overheating would be an issue.
I recorded a couple of 1 minute clips with the watch about 10-12" from my mouth and spoke at normal conversation level. Sound works but appears to be very muted. Very difficult to hear on playback unless on max volume.
I too am unable to have data access since the data apn field is not editable with AT&T as carrier. Did you still need example of the needed APN fields that previously worked?
Heart rate sensor isn’t really working as intended. I use a 15 euro pulsebelt (smart Bluetooth) instead. It registers even the smallest intervals. Built in hrm was 20-80 bpm off. You can have screen on time for hours.
TTS working as intended here. I used read aloud and Google TTS. I will download Alreader tomorrow and test further.
Edit: TTS failed to initialize on MyRunningApp.
Edit 2: TTS working in all apps. I can guide you if you still need help.
Speaking of MyRunningApp, I get random shutdowns to “android” text logo on black background after running for about an hour. Only hard reset works at this point. Ouch.
@Colin_Green I recorded a few seconds from every camera on every Android 10 (three of them) currently on the market plus one A7.1.1 watch for comparison. I put those clips in my Google Drive in a folder called Android 10 Watch Video Samples. I speak, like you, on all the clips and, like you reported, many of them are muffled. Compare with the A7.1.1 clip and you’ll see what a huge step backwards we have taken across the board for audio on video recording.
It’s a case of time @SmartWatch_Ticks
They need to work on the drivers and MTK are also involved now.
It was always going to be a challenge to get a lot of this stuff to work because of the many restrictions applied in the OS.
The other side of the coin is that the previous M6739 SOC is now very expensive as they try to phase it out.
So there is little choice but pushing ahead with Android 10 and there will be some Android 9 in the mix soon as well.
Unfortunately Android 9 has almost the same restrictions as Android 10.
So they will keep working on it.
Same here with MRA . Been testing for weeks . Sadly with no further updates this app is a dead duck . However " runmeter " is looking good . One interesting thing on A10 is .gif files work as nature intended unlike A7.1.1 where framerate can be a issue
Ok thanks.
We are looking for a more seamless solution for the apps.
Having the apps being able to work together has always been a serious problem for us.
So it makes sense that we should try to get it sorted
, a long list.
. One interesting thing on A10 is .gif files work as nature intended unlike A7.1.1 where framerate can be a issue